Mirro-Krome 60 has an induction hardened layer that is a minimum of .050″ deep with a minimum hardness of HRc 50. The chrome plate is a minimum of .0005″ thick with a hardness of approximately HRc 70.
Removal of the chrome plate and the induction hardened layer will necessitate the use of somewhat unique tooling. Maximum rigidity is required. Tool overhang kept to a minimum and the machine should be in good tight condition. Cutting insert should be oriented to a 45° side cutting edge angle (S.C.E.A.) to minimize the notch effect. Keep area being machined as close as possible to the chuck. Using a steadyrest is not recommended unless a live center in the tailstock is also incorporated in the setup.
Coolant – none
High Speed – 280/320 surface feet per minute (SFM)
Feed – .003-.005″ per revolution.
Carbide – Depth of cut: 1/8″
Horsepower – approximately 7
An abrasion resistant cutting tool should be used. Typically, hot pressed ceramics can fill this need. Cutting will generate an intense amount of heat. This is typical. Some sparking may occur. Do not apply any coolant. Do not allow the insert to dwell or rub as work hardening will occur.