Bar Grinding Centerless Vs. On-Centers – Second Part of Four Part Set
As we mentioned in our last blog; in the maintenance industry, if someone refers to grinding a steel shaft, they are most likely talking about “Centerless Grinding”. There is another method, however, and that method is called “On-Center Grinding”. A misunderstanding on which method is actually required usually results in expensive errors, and general unhappiness for all parties. Of the two types, centerless is by far the most common. So much so, that if you mention grinding a shaft, the mill or service center will assume you are discussing centerless grinding.
Centerless grinding tends to follow the outside diameter of the bar; think apple peeler. When the skin is off, you still have a recognizable apple; naked, but still looks like an apple. Grind an egg-shaped hot rolled bar, and you will have a precision finished egg. In the hands of an experienced grinding operator, many troubling issues may be corrected. Taking it to an art form, the right operator can minimize irregularities and even affect straightness; to a point. The standard in industry is centerless. So, unless specified, tolerances being discussed are taken to be based on centerless.
On-Center grinding, on the other hand, indexes on the center of both ends of the bar. The grinding head then machines the O.D. of the bar to be concentric with the I.D. (chucked up centering holes). If your bar is egg shaped, now, your ground bar will be concentric. If the bar is bent, the finished ground bar will be straight, depending on how bent it was and how much stock removal you are able to take. The roundness (concentricity) and the straightness come from the “On-Center” grinding. On center grinding requires more stock allowance “to-clean up” than centerless grinding. Where there are low spots, no stock will be removed. The on-center grinding operation will not only true up the diameter size, but, it will “machine” the bar into a true round and straight part. How do you avoid these potential problems if you are not aware of the intended grinding method? Qualify, Qualify, Qualify. If “finish size” is mentioned, ask about the grinding method. And remember; “If it doesn’t clean-up, whos wallet comes out?”
-Howard Thomas, September 5th 2018