Be careful, the two are often confused between end-user and vendor. They are not interchangeable. BEARING QUALITY refers to manufacturing restrictions that are employed, when the mill makes the steel. It is commonly referred to as “Clean Steel Production”. The processing refines the steel, removing non-metallic inclusions and generally improving the quality and core integrity of the steel. This is not something that can be achieved in subsequent processing; it either is bearing quality, or it isn’t.

BEARING FIT (TOLERANCE), is achieved by subsequent processing of a steel bar or shaft. You may accomplish this at any point prior to use of the bar; do-able on-site locally, or as a specification for subsequent processing accomplished at the mill. This, as stated, refers to the tolerance alone; making no statement in regards to the integrity nor the cleanliness of the material. Bearing Tolerance is referred to as a “minus/minus” tolerance, as opposed to a plus or minus tolerance.

Typically, and depending on diameter, the tolerance would be something like minus .001″ to minus .0015″

A NOTE ON EXPRESSING BAR TOLERANCES, it is common to hear bar tolerances specified as; “Plus nothing minus .002”, or whatever the downside tolerance is. To avoid potential problems, it is better to state both plus and minus terms with a specific decimal position. Make sure that both parties know how far out that “plus” side is carried. Is it measured to the third decimal place, or the fourth? Many “Plus Nothing” bars actually may only be measured to the third (thousandths) place which allows the bar to actually be a plus tolerance. Such as plus .0005″. Note that Bearing Fit or Bearing Tolerance insures a minus tolerance.

You may further avoid potential headaches by specifying the actual diameter wanted in terms of the actual decimal, both over and under (plus and minus), such as .2500″/.2495″.

Whether it is Bearing Quality or Bearing Fit, keep in mind that there may be an additional cost to obtain that benefit.


-Howard Thomas, Oct 18th 2018